- Tab Content
- Bikeracer2020's Activity
- About Me
- Tab Content
-
Older Activity
-
02-16-2025, 03:22 AMFrom your description.... If the hot end has a teflon tube insert that butts up to the top of the nozzle it's likely that the end of it is not cut...1 replies | 708 view(s)
-
02-12-2025, 02:18 PMFrom the pic it looks like two sides slope outwards, if this is the case and the measurements at the top exceed the build volume, then the print will...2 replies | 1332 view(s)
-
02-11-2025, 01:39 PMBikeracer2020 replied to a thread Best 3D printer for me? Comment advice. in General 3D Printing DiscussionI'm interested to know why it would be a better choice? A better choice than what, and how or why it would be a better choice?118 replies | 316360 view(s)
-
02-09-2025, 03:33 AMBikeracer2020 replied to a thread Flashforge Adventurer 3 Pro question in General 3D Printing DiscussionIt could be your nozzle is set too high when the print starts. Try adjusting the 'Z' offset in the SLICER SETTINGS to make the nozzle closer to...3 replies | 1601 view(s)
-
02-05-2025, 03:16 AMBikeracer2020 replied to a thread Confusion About Print Speed and Max Volumetric Speed (MVS) in Default Profiles in QiDi 3D Printer ForumThis might help..... https://3dprintbeginner.com/bambu-studio-fine-tuning-tips-and-tricks/2 replies | 1513 view(s)
-
01-28-2025, 10:45 AMYou could do a cold pull to clear any residual filament from your nozzle, see youtube for a demo of this. You can get lengths of specific nylon...4 replies | 3515 view(s)
-
01-23-2025, 04:01 PMRecommending a printer is a question that gets asked a lot and posters will reply with different opinions frequently based on youtube reviews. ...5 replies | 3970 view(s)
-
01-23-2025, 04:29 AMPossibly under extrusion. If you try Orca slicer there are several calibration tests built into it.2 replies | 3242 view(s)
About Bikeracer2020
Basic Information
Statistics
Total Posts
- Total Posts
- 699
- Posts Per Day
- 0.40
General Information
- Join Date
- 05-07-2020
Please help dial in my printer
Yesterday, 11:02 AM in Tips, Tricks and Tech Help