Bikeracer2020
Super Moderator

Try bed temp around 95C. Drop your speed to 30-35. Slower is better. Preheat chamber with bed for a good 30 mins before starting print. On no...

I think this is a printer specific problem, it didn't happen with either a Raise 3D E2, or BCN W27 Epsilon. Advice from Qidi is that a different...

Thanks, I hope that the moderators will pay attention.[/QUOTE Soon it will be 'open season" on spammers that infect this forum.

Leveling a bed with a feeler gauge will only tell if the bed is flat, not if it is level to the 'X' and 'Y' axis. If the bed was tilted at 30...

Look in your slicer settings for where you can hopefully change the global 'Z' axis setting. I think you will have to put a negative input there,...

I think this is printer specific because a print with holes in it that I did on a different printer does not show the same problem of raised...

Print one of the many leveling tests from Thingiverse or Thangs. Then you will be able to tell if your extruder nozzle is perhaps to high from the...