Bikeracer2020
Super Moderator

A photo would help.

You can always email Qidi and ask them. I very rarely print anything other than ASA and I know the standard extruder set up does not like...

If it's anything like the standard extruder in my X CF pro anything over 240 will probably give you problems.

Perhaps a picture of what you need would help, however there are dozens of different latches on Amazon. I made a latch for my gate using ASA

Try 'Z' hop on layer change, just something to try, it might work. There should also be a command in the slicer to avoid moving over printed parts.

A simple Google search would have provided you with the following answer....... PLA+ is an augmented version of PLA. PLA+ contains additives and...

I really like Prusaslicer because it's so easy to find out what each command actually does just by holding the pointer over it and a web page comes...

Presuming you are using PLA, I believe there will be a standard PLA generic profile for each printer selected in Cura, but I am not sure. It could...

From my limited experience, you are asking for a wall thickness of 1.2mm with a wall line count of ten with a 0.4mm line width ? Three line widths...

There's an old addage that you can make small things on a big lathe, but you can't make big things on a small lathe. It can be frustrating trying...