piotr1990
Student

Got it going now. They both work now but on 100% speed or 0. If I try to lower it down even to 99% it will stop.

Pins configuration.adv.h Do you see anything wrong?

Does the fan that blow at the heatsink should blow straight after you switch on the printer? My multi meter does not show any voltage when checking...

Think there was just something wrong with that g code of the "normal dog" sample from Creality. Maybe the file got corrupted or something. It was...

Thank you. It turned out I had a bit of problems with connectivity of my Z stop sensor. That was a bit of my own fault as I had to use a bit of...

Check that blue filament guide that you made if you can feel a bit resistance when you manually pull the filament. In time the filament will rub that...

I finally got the SD card working after all this time. It's nice and quiet now. But still got issues with it. I noticed then after I auto home it the...

You may want to also check this : https://www.youtube.com/watch?v=7BURpQNXrDA It's about standard support and my favorite, "tree support" Witch I...

A little update. I finally upload that firmaware. Had to use my friends laptop. It seems like after you try to connect the board 2nd time that's it....

I think this may be the problem. I try already uninstal this driver and plug the board back in hoping it to reinstall correctly but nothing....

I try to use Atom but it dosen't work on my PC. I just need this for one go. Do you see any problems in that log? Or is it possible for you to...

Well never mind I already got the ones that you recommended. After hours of researching I build the software marlin to it dosen't want to upload it.

would upload the entire folder but its around 200mb

I'm trying to upload the soft with VSC via USB but on my compitation list everything is ignored and 1 faillog:> Executing task:...