fred_dot_u
Staff Engineer

Now that I'm awake, I used Fusion 360 to import both meshes, used Mesh/Modify/Combine and created the attached file. It passes Meshmixer's Inspector....

Okay, that was WRONG. You're asking for the difference and I did a combine. Sheesh. I'll get back on it in the morning.

I selected the Queen component, then performed a plane cut and aligned the cutting plane to the monolith. On execution, I selected both components...

Rather than firing up F360 again, I loaded the full STL into Meshmixer and did a "separate shells" then exported each letter to its own file,...

I confirmed that I have Microgramma D Bold Extended typeface installed in my computer. I then started Fusion 360 and started a new sketch on the x/y...

Montana chalk spray (and others) are on Amazon with various colors from which to choose. White is the most common selection, for best reflectivity....

TGFT, (may I call you TGFT?), without a clear analysis of the failure mode, one can only make a guess. The photos of the character exhibit specular...

Without a clear analysis of the failure mode, one can only make a guess. The photos of the character exhibit specular reflections. The bright dots on...

First point, one hundred percent infill isn't going to make the part stronger than a lower value. One can have as low as 20 to 25 percent infill and...