fred_dot_u
Engineer

If you have other filament with which to try, that would be another point of information. 60 mm per second is a pretty good speed, but what happens...

The inconsistency would mean the moisture idea isn't valid. It's really difficult to tell from the photo and the limitations of the information...

At first glance, that looks like overextrusion, but your comment about unused filament makes me wonder if you have moisture in your filament. If...

That's unfortunate. I have a half dozen different brands and materials of white, PLA, ABS, HIPS (and ASA in a sealed box). Of the ones I just...

The change to non-white coloration is an indication that the "white" LEDs are not a true white color temperature. If you are seeing white under...

An inexpensive food dehydrator is one of the better ways to clear a spool of excess moisture. I've seen references of duration from four hours (seems...

A popping sound would indicate excessive moisture content in the filament. A clicking sound can come from the extruder motor, indicating a clog in...

Soft PLA is a product, but I don't think it would hold up well to the heat. There are TPU filaments which are flexible and quite strong. The rigidity...

Discord has a section for QIDI printers and a separate sub-section for that particular printer. I'm not fully versed in Discord terms, and section...

Give this a look. I was able to construct a hollow cylinder with the inside diameter to match your desired dimension, with an outside diameter only a...

Was this an openly available file from a 3D printing resource such as Thingiverse or Printables?

Do you have the source file from which the STL was created?

Do you see in the slicer the flaws that appear in the photo? It's difficult to determine from the image what you are determining to be failure points.

Do you get displayed error indicators in Meshmixer from the file? If you can post the STL, it might be easier to determine a solution than to attempt...