TommyDee
Technologist
Find latest postsMini Statistics
- Join Date
- 01-06-2019
- Last Activity
- Yesterday 11:28 PM
- Avatar
Recent Visitors
This page has had 2,130 visits
- Tab Content
- TommyDee's Activity
- About Me
-
Older Activity
-
06-06-2019, 02:30 PMOn my printers, which are fairly accurate on temps, I get ~250C on 3rd party ABS. And I get away with having no heated bed (thermal chamber on one;...5 replies | 495 view(s)
-
05-31-2019, 10:51 AMTommyDee replied to a thread 3D Ignorant Vet Needs Duck Bill Printed in 3D Printing Prostheses & Robotic LimbsYour next trick will be the modeling part. There is precious little software that will let you do a premium crafting of the bill at a reasonable...5 replies | 843 view(s)
-
05-29-2019, 09:10 PMOddly enough, restrictive bowden tubes. The "tractor'd" filament becomes wide enough to add resistance to filament feed... sufficient to finally jam...4 replies | 841 view(s)
-
05-26-2019, 07:19 PMTommyDee replied to a thread 3D Ignorant Vet Needs Duck Bill Printed in 3D Printing Prostheses & Robotic LimbsYou'll begin with learning to scan the remaining bill and figuring out a proper attachment interface and adhesives. Then a matter of material...5 replies | 843 view(s)
About TommyDee
Basic Information
Statistics
Total Posts
- Total Posts
- 122
- Posts Per Day
- 0.75
General Information
- Last Activity
- Yesterday 11:28 PM
- Join Date
- 01-06-2019
- Referrals
- 0
3D Model not showing all sides??
06-17-2019, 02:16 PM in 3D Printing Slicer Discussion