airscapes
Engineer
Find latest postsMini Statistics
- Join Date
- 05-20-2018
- Last Activity
- Yesterday 02:16 PM
Recent Visitors
- 3Dspacer,
- bjonson974,
- DanielCrown,
- HelenGarcia,
- machinedalal,
- Mirad1,
- Nanookofthenorth,
- njpdlstarcom,
- OcenTane,
- René--
- Tab Content
- airscapes's Activity
- About Me
-
Older Activity
-
09-16-2023, 02:32 PMairscapes replied to a thread Will TPU stick to TPU at room temp.? in General 3D Printing DiscussionWhy not just buy a 3d printing pen, a small roll of TPU and try it on the timing belt yourself...8 replies | 1189 view(s) -
09-14-2023, 09:44 AMFor all intents and purpose NO. Could you mount the belt to the build plate so it is flat, then measure the offset need to apply the first layer to...2 replies | 933 view(s)
-
09-10-2023, 10:08 PMairscapes replied to a thread Can somebody help please I'm losing my mind! in 3D Design Feedback / Assistance / Work-in-Progressonshape.com is fully functional software and is free but your models are open to anyone with an account.. If you pay a fee your stuff is private.3 replies | 1660 view(s)
-
09-10-2023, 10:06 PMairscapes replied to a thread Is ASA much easier to print than people think ? in Tips, Tricks and Tech HelpYes, this forum is the worst7 replies | 1985 view(s)
-
09-10-2023, 12:38 PMairscapes replied to a thread Cannot figure out the print issue/ E3S1Pro w Sonicpad/ ty in advance in General 3D Printing DiscussionIf I had to guess the nozzle is too close to the bad.. Starting Z offset need to be increased, however that is done on this particular printer I do...1 replies | 694 view(s)
-
08-30-2023, 01:07 PMyour sensor need air flow.. you may want send that one back and grab this one.. When I wanted a sensor for my indoor hydroponics tent I considered an...2 replies | 876 view(s)
About airscapes
Basic Information
Statistics
Total Posts
- Total Posts
- 546
- Posts Per Day
- 0.28
General Information
- Last Activity
- Yesterday 02:16 PM
- Join Date
- 05-20-2018
Will TPU stick to TPU at room...
09-16-2023, 04:42 PM in General 3D Printing Discussion