- Tab Content
- airscapes's Activity
- About Me
-
Older Activity
-
Today, 05:25 PMI have lots of PETG mounts holding cameras and light which are outside in the sun in the Philadelphia PA area where it hit 100F in the shade. You...3 replies | 60 view(s)
-
Today, 01:36 PMNever have any of the issues you mention with ABS. sounds like bad/wet abs or your z offset is too high.. of course no enclosure PETG is the other...3 replies | 60 view(s)
-
Yesterday, 10:40 PMslow down.. try 40mmS.. infill 35%, layer height .32 replies | 140 view(s)
-
02-10-2025, 09:13 AMNot familiar with that slicer but in S3d slicer there is a setting that says how far to print the skirt from the part, you may want to increase that...2 replies | 274 view(s)
-
01-23-2025, 05:37 PMWhat type would that be? You asked a question and I tried to answer it. i had no idea how much metal printers cost but I did know they are not in...5 replies | 2360 view(s)
-
01-23-2025, 04:42 PMNot to be unhelpful, but a simple google search for 3d printing metal machines returns this: A Metal 3D Printer may cost you anywhere between...5 replies | 2360 view(s)
-
01-20-2025, 11:00 PMI am confused.. looks to me if you put the far side to the left when looking at the second picture on the build plate no support would be needed.....4 replies | 3006 view(s)
-
01-18-2025, 03:02 PMairscapes replied to a thread Design Approach and Filament Reco Needed in General 3D Printing DiscussionThat was the correct choice. Reasons Not to use ABS or Nylon for this project ABS and Nylon both require an enclosure and you did not say what you...7 replies | 2804 view(s)
-
01-17-2025, 05:59 PMairscapes replied to a thread Design Approach and Filament Reco Needed in General 3D Printing DiscussionThis design should work fine. However it seems that wood or pvc trim would be faster easer and less expensive. Fare as this model goes, I assume...7 replies | 2804 view(s)
-
01-15-2025, 08:41 AMYes no heat. You can also try lowering the hot end temp so you are at the minimum range for your particular brand of TPU.. what are you using...5 replies | 2630 view(s)
-
01-15-2025, 08:37 AMairscapes replied to a thread Slice Engineering Plastic repellent coating in General 3D Printing Discussionbuy a brass sued brush...4 replies | 2634 view(s)
-
01-14-2025, 11:14 PMYes no heat.. If you are using PEI try the textured side . make sure your Z offset is correct.. clean the plate with windex between prints.. the...5 replies | 2630 view(s)
About airscapes
Basic Information
Statistics
Total Posts
- Total Posts
- 612
- Posts Per Day
- 0.25
General Information
- Last Activity
- Today 05:25 PM
- Join Date
- 05-20-2018
Confusion About Print Speed and...
02-05-2025, 11:23 AM in QiDi 3D Printer Forum