airscapes
Engineer

did you fully dry the nylon before you used it.. have to do that every time you use it

Why not just buy a 3d printing pen, a small roll of TPU and try it on the timing belt yourself...

For all intents and purpose NO. Could you mount the belt to the build plate so it is flat, then measure the offset need to apply the first layer to...

onshape.com is fully functional software and is free but your models are open to anyone with an account.. If you pay a fee your stuff is private.

Yes, this forum is the worst

If I had to guess the nozzle is too close to the bad.. Starting Z offset need to be increased, however that is done on this particular printer I do...

your sensor need air flow.. you may want send that one back and grab this one.. When I wanted a sensor for my indoor hydroponics tent I considered an...