airscapes
Engineer

That was the correct choice. Reasons Not to use ABS or Nylon for this project ABS and Nylon both require an enclosure and you did not say what you...

This design should work fine. However it seems that wood or pvc trim would be faster easer and less expensive. Fare as this model goes, I assume...

Yes no heat. You can also try lowering the hot end temp so you are at the minimum range for your particular brand of TPU.. what are you using...

buy a brass sued brush...

Yes no heat.. If you are using PEI try the textured side . make sure your Z offset is correct.. clean the plate with windex between prints.. the...

Make sure your z offset is correct and maybe if increase +.03. Do not heat the build plate, if you have a choice of build plates use a PEI powder...

3d printing is not injection molding and by design it makes items one thread and layer at a time, so other than has been mentioned above, the...

Know the feeling.. after 23 years at the same company getting outsourced (me and the entire IT infrastructure team to India).. will be back in the IT...

Everyone wants you money.. Overture is decent and well priced. Esun is also my go to for PETG, I use very little PLA but have used Overture. There...

Check out onshape.com it is free and is fairly easy to learn.

I would suggest using google to search on topics. 3D printing as a hobby is like all hobbies, there are many facets to it and you need to learn...

have both of my enclosures sitting on top of a dress in an extra bedroom.. No they do not need to be level. they do need to be sturdy as the printer...

We have some temporary doors set up in our house to facilitate the introduction of a semi feral cat to the indoor cats. The one door has a squeaky ...

Well, have your read all the instructions and info on the websites that are for the machine, the slicer and any 3d model software. unfortunately...

I fail to understand why people have issues with PETG.. Only thing I change between ABS PETG PLA is the temperatures.. no issues I think it is all...