- Tab Content
- airscapes's Activity
- About Me
-
Older Activity
-
Yesterday, 10:40 PMslow down.. try 40mmS.. infill 35%, layer height .31 replies | 26 view(s)
-
02-10-2025, 09:13 AMNot familiar with that slicer but in S3d slicer there is a setting that says how far to print the skirt from the part, you may want to increase that...2 replies | 233 view(s)
-
01-23-2025, 05:37 PMWhat type would that be? You asked a question and I tried to answer it. i had no idea how much metal printers cost but I did know they are not in...5 replies | 2337 view(s)
-
01-23-2025, 04:42 PMNot to be unhelpful, but a simple google search for 3d printing metal machines returns this: A Metal 3D Printer may cost you anywhere between...5 replies | 2337 view(s)
-
01-20-2025, 11:00 PMI am confused.. looks to me if you put the far side to the left when looking at the second picture on the build plate no support would be needed.....4 replies | 2960 view(s)
-
01-18-2025, 03:02 PMairscapes replied to a thread Design Approach and Filament Reco Needed in General 3D Printing DiscussionThat was the correct choice. Reasons Not to use ABS or Nylon for this project ABS and Nylon both require an enclosure and you did not say what you...7 replies | 2790 view(s)
-
01-17-2025, 05:59 PMairscapes replied to a thread Design Approach and Filament Reco Needed in General 3D Printing DiscussionThis design should work fine. However it seems that wood or pvc trim would be faster easer and less expensive. Fare as this model goes, I assume...7 replies | 2790 view(s)
-
01-15-2025, 08:41 AMYes no heat. You can also try lowering the hot end temp so you are at the minimum range for your particular brand of TPU.. what are you using...5 replies | 2604 view(s)
-
01-15-2025, 08:37 AMairscapes replied to a thread Slice Engineering Plastic repellent coating in General 3D Printing Discussionbuy a brass sued brush...4 replies | 2610 view(s)
-
01-14-2025, 11:14 PMYes no heat.. If you are using PEI try the textured side . make sure your Z offset is correct.. clean the plate with windex between prints.. the...5 replies | 2604 view(s)
-
01-12-2025, 07:16 PMMake sure your z offset is correct and maybe if increase +.03. Do not heat the build plate, if you have a choice of build plates use a PEI powder...5 replies | 2604 view(s)
-
01-12-2025, 09:52 AM3d printing is not injection molding and by design it makes items one thread and layer at a time, so other than has been mentioned above, the...2 replies | 2398 view(s)
About airscapes
Basic Information
Statistics
Total Posts
- Total Posts
- 610
- Posts Per Day
- 0.25
General Information
- Last Activity
- Yesterday 10:40 PM
- Join Date
- 05-20-2018
Confusion About Print Speed and...
02-05-2025, 11:23 AM in QiDi 3D Printer Forum