- Tab Content
- airscapes's Activity
- About Me
-
Older Activity
-
Yesterday, 08:52 AMairscapes replied to a thread Ultra Newbie questions. Cheap 2 color unit? Heat tolerance of parts. in General 3D Printing DiscussionI would suggest doing your part design and then have the model printed by a printing service. You should do a bit more research on types of filament...1 replies | 310 view(s)
-
02-13-2025, 07:15 PMNever printed a 3 day part.. my build volume is only 8x10x8.. My enclosure has no extra heater anymore, it is no needed. For ABS the heat of the...3 replies | 1041 view(s)
-
02-12-2025, 05:25 PMI have lots of PETG mounts holding cameras and light which are outside in the sun in the Philadelphia PA area where it hit 100F in the shade. You...3 replies | 625 view(s)
-
02-12-2025, 01:36 PMNever have any of the issues you mention with ABS. sounds like bad/wet abs or your z offset is too high.. of course no enclosure PETG is the other...3 replies | 625 view(s)
-
02-11-2025, 10:40 PMslow down.. try 40mmS.. infill 35%, layer height .33 replies | 750 view(s)
-
02-10-2025, 09:13 AMNot familiar with that slicer but in S3d slicer there is a setting that says how far to print the skirt from the part, you may want to increase that...2 replies | 832 view(s)
-
01-23-2025, 05:37 PMWhat type would that be? You asked a question and I tried to answer it. i had no idea how much metal printers cost but I did know they are not in...5 replies | 3019 view(s)
-
01-23-2025, 04:42 PMNot to be unhelpful, but a simple google search for 3d printing metal machines returns this: A Metal 3D Printer may cost you anywhere between...5 replies | 3019 view(s)
-
01-20-2025, 11:00 PMI am confused.. looks to me if you put the far side to the left when looking at the second picture on the build plate no support would be needed.....4 replies | 3250 view(s)
-
01-18-2025, 03:02 PMairscapes replied to a thread Design Approach and Filament Reco Needed in General 3D Printing DiscussionThat was the correct choice. Reasons Not to use ABS or Nylon for this project ABS and Nylon both require an enclosure and you did not say what you...7 replies | 3390 view(s)
-
01-17-2025, 05:59 PMairscapes replied to a thread Design Approach and Filament Reco Needed in General 3D Printing DiscussionThis design should work fine. However it seems that wood or pvc trim would be faster easer and less expensive. Fare as this model goes, I assume...7 replies | 3390 view(s)
About airscapes
Basic Information
Statistics
Total Posts
- Total Posts
- 614
- Posts Per Day
- 0.25
General Information
- Last Activity
- Today 10:59 AM
- Join Date
- 05-20-2018
Flashforge Adventurer 3 Pro...
02-13-2025, 01:47 AM in General 3D Printing Discussion