airscapes
Engineer

It means, learn how the slicer program works and the quirks related to your printer so you can get a good result.

I would suggest doing your part design and then have the model printed by a printing service. You should do a bit more research on types of filament...

Never printed a 3 day part.. my build volume is only 8x10x8.. My enclosure has no extra heater anymore, it is no needed. For ABS the heat of the...

I have lots of PETG mounts holding cameras and light which are outside in the sun in the Philadelphia PA area where it hit 100F in the shade. You...

Never have any of the issues you mention with ABS. sounds like bad/wet abs or your z offset is too high.. of course no enclosure PETG is the other...

slow down.. try 40mmS.. infill 35%, layer height .3

Not familiar with that slicer but in S3d slicer there is a setting that says how far to print the skirt from the part, you may want to increase that...

What type would that be? You asked a question and I tried to answer it. i had no idea how much metal printers cost but I did know they are not in...

Not to be unhelpful, but a simple google search for 3d printing metal machines returns this: A Metal 3D Printer may cost you anywhere between...

I am confused.. looks to me if you put the far side to the left when looking at the second picture on the build plate no support would be needed.....