- Tab Content
- airscapes's Activity
- About Me
-
Older Activity
-
01-23-2025, 05:37 PMWhat type would that be? You asked a question and I tried to answer it. i had no idea how much metal printers cost but I did know they are not in...5 replies | 2203 view(s)
-
01-23-2025, 04:42 PMNot to be unhelpful, but a simple google search for 3d printing metal machines returns this: A Metal 3D Printer may cost you anywhere between...5 replies | 2203 view(s)
-
01-20-2025, 11:00 PMI am confused.. looks to me if you put the far side to the left when looking at the second picture on the build plate no support would be needed.....4 replies | 2718 view(s)
-
01-18-2025, 03:02 PMairscapes replied to a thread Design Approach and Filament Reco Needed in General 3D Printing DiscussionThat was the correct choice. Reasons Not to use ABS or Nylon for this project ABS and Nylon both require an enclosure and you did not say what you...7 replies | 2685 view(s)
-
01-17-2025, 05:59 PMairscapes replied to a thread Design Approach and Filament Reco Needed in General 3D Printing DiscussionThis design should work fine. However it seems that wood or pvc trim would be faster easer and less expensive. Fare as this model goes, I assume...7 replies | 2685 view(s)
-
01-15-2025, 08:41 AMYes no heat. You can also try lowering the hot end temp so you are at the minimum range for your particular brand of TPU.. what are you using...5 replies | 2502 view(s)
-
01-15-2025, 08:37 AMairscapes replied to a thread Slice Engineering Plastic repellent coating in General 3D Printing Discussionbuy a brass sued brush...4 replies | 2496 view(s)
-
01-14-2025, 11:14 PMYes no heat.. If you are using PEI try the textured side . make sure your Z offset is correct.. clean the plate with windex between prints.. the...5 replies | 2502 view(s)
-
01-12-2025, 07:16 PMMake sure your z offset is correct and maybe if increase +.03. Do not heat the build plate, if you have a choice of build plates use a PEI powder...5 replies | 2502 view(s)
-
01-12-2025, 09:52 AM3d printing is not injection molding and by design it makes items one thread and layer at a time, so other than has been mentioned above, the...2 replies | 2309 view(s)
About airscapes
Basic Information
Statistics
Total Posts
- Total Posts
- 608
- Posts Per Day
- 0.25
General Information
- Last Activity
- Yesterday 07:45 PM
- Join Date
- 05-20-2018
Confusion About Print Speed and...
02-05-2025, 11:23 AM in QiDi 3D Printer Forum