- Tab Content
- airscapes's Activity
- About Me
-
Older Activity
-
02-13-2019, 09:29 AMPETG is particular about starting height.. needs to be correct. No idea how you configure that on your printer. I have use eSun PETG on clean glass...1 replies | 164 view(s)
-
02-12-2019, 01:03 PMairscapes replied to a thread PLA and air pressure. Any advice on thickness for ~100 psi in 3D Printer Parts, Filament & Materials3d printed parts are most likely going to leak.. and pla would certainly not be the right choice for a part that could burst. Nylon/EPA, Taulman...4 replies | 536 view(s)
-
01-27-2019, 09:19 AMKeep in mind what the machine is actually doing.. A solid plastic filament is being pushed into a tiny hot chamber to melt, then under pressure...5 replies | 502 view(s)
-
01-27-2019, 12:13 AMairscapes replied to a thread Sustainable solution: Auto-off-upon-finish Function: 3d Printer Auto-off Switchers in Free Self PromotionNot something I really need.. If the print finishes.. the PS and and fan can run until I wake up...6 replies | 1317 view(s)
-
01-27-2019, 12:09 AMif that is 80mmS then SLOW THE HECK DOWN! No idea what you are printing but try the same model at 50mmS and see what changes.5 replies | 502 view(s)
-
01-25-2019, 07:44 PMDe-lamination has always been printing too cold, at least for me. Try 225. Just because you have your hot end set to 225 does not mean it...4 replies | 360 view(s)
-
01-25-2019, 03:00 PMTry slicing this 15x15x2x.6 mm square and printing it. When complete measure it with your Digital caliper (you really need one if you want to do 3d...4 replies | 360 view(s)
-
01-22-2019, 09:34 AMGoogle Denture repair epoxy11 replies | 3348 view(s)
About airscapes
Basic Information
Statistics
Total Posts
- Total Posts
- 106
- Posts Per Day
- 0.38
General Information
- Last Activity
- Today 07:03 AM
- Join Date
- 05-20-2018
- Referrals
- 0
When will we be 3D printing all...
Yesterday, 04:09 AM in General 3D Printing Discussion