Roberts_Clif
Staff Engineer

There could be several problems. New Firmware configuration. Print speed to fast causing hot end to cool. Bad hot end heater. Loose hot end...

Was going the suggest just that, though you are correct. Have a Pair of the Any cubic Kobra 3 Combo 's Purchased a full set of nozzles 0.2mm 0.4mm...

Do not know how good the information is though you can search again using the description on the link. I visited the HzdaDeve store and could not...

I found this link

Partly because I own a pair of these color printers, an partly because we could use more technically minded individuals. I would suggest looking...

Hi I have been looking for a users manual for Orca Slicer 2.3.0 or anything even close as to allow me to use the full potential of slicers. Would...

Here we have a Painted object shown in the photo below. If the Painted is in Object mode then they will have a place to select/change the...

Yesterday I found the newest Orca Slicer 2.3.0 RC Build 79a5a9b build and printed using a USB Flash drive. This means maybe the Anycubic Kobra 3...