Roberts_Clif
Staff Engineer

Not sure exactly what I am looking for. Well I see a solid layer below a interweaving mesh topped with a 2nd solid top layer. This design looks...

You are welcome. I have had New filament just removed from packaging cause me similar problems. Though tuning a 3D Printer can be quite...

You are welcome. I have my 3D printer setup to print the first layer at 32% then the remaining layers at 72-82%. This is relative to which...

Sometime it is not easy deduce the cause of a missed print. Have had prints where the filament I was using was spliced with higher temperature...

The only time I get is when I try to 3D Print the first layer too fast. Sometimes 1st and 2nd layers then it will finish 3D printing perfectly.

Check the lead screws it sounds like the side making the most noise could have too much tension an could be out of alignment. Once my 3D Printer the...

In a round about way I made back the money spend on four of my 5 3D Printer / CNC projects. My 3D Printers have saved me purchasing many things that...