Roberts_Clif
Staff Engineer
Find latest postsMy Social Networking
Mini Statistics
- Join Date
- 06-12-2017
- Last Activity
- Today 10:40 AM
- Avatar
More 1 Friend
Recent Visitors
- Bruce19,
- Deano,
- donaldblake,
- Edopex,
- HelenGarcia,
- johnmichael,
- njpdlstarcom,
- OcenTane,
- ROTTO,
- vladimir
- Tab Content
- Roberts_Clif's Activity
- About Me
- Friends
- Tab Content
-
Older Activity
-
Today, 10:26 AMNot sure why you cannot print ABS, I 3D Printed ABS in a basement using a simple boxed enclosure. Making sure to vent all fumes outside though the...5 replies | 3282 view(s)
-
01-01-2025, 09:27 PMRoberts_Clif replied to a thread Oldest newbee could use some advice! in General 3D Printing DiscussionI have never worked with a QIDI Tech Q1 PRO 3D printer before though, most problems with 3D Printers have very similar solutions. So we should be...9 replies | 3325 view(s)
-
12-31-2024, 03:38 PMRoberts_Clif replied to a thread Setting up Adventurer 5M Pro for printing. Little help? in FlashForge Forumhttps://www.youtube.com/watch?v=CustyiqfK_82 replies | 2067 view(s)
-
12-24-2024, 04:10 PM1. best firmware (no idea whats on it) with configs etc ?? One : Marlin version 2 is my favorite others prefer RepRap, Repetier, Klipper, and more...5 replies | 4201 view(s)
-
12-24-2024, 03:51 PMI created my first model knowing very little about Cad, I heard about Fusion 360 Free for Hobbyist downloaded and installed to software. Knowing...5 replies | 4201 view(s)
-
12-24-2024, 03:40 PMRoberts_Clif replied to a thread Oldest newbee could use some advice! in General 3D Printing DiscussionI have written a post about just that subject. Fusion 360 is free for Hobbyist link below....9 replies | 3325 view(s)
-
12-24-2024, 08:08 AMAs far as learning, I hear you Purchased my 1st 3D printer years ago, it was so interesting, I watched it 3D Print entire models in fascination. ...5 replies | 4201 view(s)
-
12-24-2024, 08:06 AMRoberts_Clif replied to a thread Oldest newbee could use some advice! in General 3D Printing DiscussionAs far as learning, I hear you Purchased my 1st 3D printer years ago, it was so interesting, I watched it 3D Print entire models in fascination. ...9 replies | 3325 view(s)
-
12-18-2024, 06:38 PMHave you looked at Anycubic Slicer Next is an open-source slicing software developed based on Orcaslicer Check it Out....1 replies | 3465 view(s)
About Roberts_Clif
Basic Information
About Roberts_Clif
- Location:
- Washington State, USA
- Occupation:
- Electroncis Tech / IT / Programmer
- Thingiverse:
- Roberts_Clif
Statistics
Total Posts
- Total Posts
- 1,193
- Posts Per Day
- 0.43
General Information
- Last Activity
- Today 10:40 AM
- Join Date
- 06-12-2017
Hello all
01-12-2025, 09:52 AM in General 3D Printing Discussion