Roberts_Clif
Staff Engineer
Find latest postsMy Social Networking
Mini Statistics
- Join Date
- 06-12-2017
- Last Activity
- 01-29-2023 03:37 PM
- Avatar
Recent Visitors
This page has had 44,477 visits
- Tab Content
- Roberts_Clif's Activity
- About Me
- Tab Content
-
Older Activity
-
01-29-2023, 03:33 PMRoberts_Clif replied to a thread First time 3D printing, weird seam... in Tips, Tricks and Tech HelpWould like more information on the position of the model while 3D Printing. Though without any further information, i suspect that the area where...3 replies | 445 view(s)
-
01-20-2023, 08:05 AMThe last lines of my startup g-code is always in the Slicer M420 S1 ; Bed Leveling turned On M106 P1 S128 ; P1 = 2nd Fan set 50% Speed M220...9 replies | 926 view(s)
-
01-17-2023, 04:21 PMWe read here you have a SN04 Proximity sensor, It would help if you stated what 3D Printer you have. A few pictures of your 3D Printer could also be...2 replies | 707 view(s)
-
01-16-2023, 07:13 AMIt appears you are doing every thing in the correct order. Leveling the bed is kind of an Art until you have more experience under your belt some...9 replies | 926 view(s)
About Roberts_Clif
Basic Information
About Roberts_Clif
- Location:
- Washington State, USA
- Occupation:
- Electroncis Tech / IT / Programmer
- Thingiverse:
- Roberts_Clif
Statistics
Total Posts
- Total Posts
- 1,161
- Posts Per Day
- 0.56
General Information
- Last Activity
- 01-29-2023 03:37 PM
- Join Date
- 06-12-2017
Sputtering, poor base adherance
01-27-2023, 04:27 PM in General 3D Printing Discussion