Roberts_Clif
Staff Engineer

Using my slicer I can select a Seam Position of Random then the Start Seam becomes invisible into this random starting position.

Maybe I misunderstood, Can you home or Level the 3D Printer without hitting the bed or Doe it hit the bed only when 3D Print starts.

Please read this web site

This could be a sign of moisture absorbed into the filament try a different roll of filament.

Hello: Colorado Have you tried to reset your 3D Printer settings to Factory Defaults. Your LCD has a setting to reset to factory settings or...

Using Hair Spray can help, Or printing closer to the print bed by 0.1mm can also help with adhesion. Sometime I print on vinyl transfer Paper Tape...

Cura has the ability to change at Z

I have never had any problems with multiple piece models just print them one at a time they fit together. Sometimes they need a little sanding...

Not on your list TRONXY® X5SA-2E Dual Colors 3D Printer Kit CoreXY with Dual Titan Extruder Dual Z axis 330*330*400mm Cura I use two and older...

I have two of these One, two They have suited me well for four years time. Today they look like the image below. Before Purchasing the 3D...

This could note under extrusion, though your raft is looking good. Is the print speed or temperature changing during print. I started with PLA...

I have posted everything believed would help someone with the same 3D Printers I have. An after a while started helping others with there problems...

I have printed so many models almost perfectly. I rarely listen when someone who tells me that my 3D Printer is no good. If I have to purchase...

Post the filament are you using and at what temperature are you trying to 3D Print.

Stated in post load a Project file though you have to import a STL files and other formats.

When printing using higher layer heights this happens on occasions. I use Prusaslicer 2.3.0 then when I get close to these areas I change to a...

It appears that you may have bed adhesion problems. Clean the bed with a 91% isopropyl alcohol, then try Aqua Net hair spray on the bed surface to...

If you want smoother surfaces look for a setting called ironing in your slicer. Set for top an bottom surfaces or all flat surfaces.

3D Printers start at varying prices from low to very high. Some 3D Printers claim to be able to 3D Print though are not rigid enough to to maintain...

Loading no -:- Importing Yes Prusaslicer works from a project file mainly 3mf & amf files. You can import the Files make any changes you require...

I assumed you would post like you did if you had any questions. Files I attached allow you to use a different slicer to slice the models for...

Here are some files to allow you to use Slic3r or Prusaslicer.

Well we are here just did not see a question. Do you need help or only posing to show us what you are doing.

Print speed is what each individual 3D Printer / Model to be printed will handle. Example My 3D Printer having a rigid frame allows me to 3D Print...

I have been working with electronics most of my life, most of all problems could have been prevented with added cooling or vent fans. With one...

Why is it that every thing has to be re-named as time passes this was called a cracked solder joint or cold solder joint in my time. Cold solder...