Roberts_Clif
Staff Engineer

I do understand I have printed on Vinyl transfer paper tape. Will Vinyl transfer paper Hold my Part Well I guess this shows that it will.

I remember when first a PEI build sheet thought would never get anything to stick until after printing ABS. Then all my filament was sticking well,...

OK every thing is working although the PEO-PET bed is not holding the PLA as well as expected any suggestions what I should do to correct...

After taking a real close look at my 3D Printers. I have made a decision that there are so many loose parts that I need to do complete ...

Finally got the 1st 3D Printer working correctly, kind of, the bed adhesion is not even close to what I was expecting. IdeaFormer 256x268mm Anycubic...

I have had a slow movement back into 3D Printing after about the same of time frame. Purchased a Big Tree Tech SKR Pro V1.1 32bit Controller For my...