Roberts_Clif
Staff Engineer

OK then maybe your nozzle is not at the correct print level. My 3D Printers are nothing much I found that in a enclosure I can 3D Print ABS at...

You are most welcome, this is how I stay informed and keep my own 3D Printers working. Helping others keeps me up to date with all 3D Printer...

I am having problems sense purchasing this newer what is called a smooth spring steel print bed. Until I gouged it with the nozzle and covered if...

Is the layer shift on the X or Y or on both axis's Have you watched the print, does the nozzle seen to run away then return and continue like...

In the image below is this the shifting you are seeing https://3dprintboard.com/attachment.php?attachmentid=19882&stc=1&d=1732980254...

https://3dprintboard.com/attachment.php?attachmentid=19875&stc=1&d=1732665026 Download Marlin 2.1.2.5 " Download and Configurations files. Unzip...

While the core functionality remains similar, some minor tweaks might be necessary depending on the specific Ender 3 model (like Ender 3 Pro, Ender...

I appears found most of the information Just need the exact name of the Ender 3 Printer Ender 3, Ender 3 Max, Ender 3 Pro, Ender 3 S1, S2 , V2, V2...

Do not know the difference what controller did that one have was it the 4.2.2 or the 1.1.5 with BL Touch or end stop switch.

Do not see much difference mine controller has a ARM-level Cortex-M4 168 MHz STM32F407ZGT6 chip, your uses LPC1769 120MHZ chip. My Marlin 2.1.2.2...

This is the controller I just purchased it is a BigTreeTech Pro V1.1 with TMC 2209 drivers. I have already configured marlin though still designing...

I do not see a problem with helping you out here. I have updated my 3D Printers from Marlin-1.1.0-RC6_Hici3-1.1.0-RC6_CL061316a to Marlin-2.1.2 And...

I had this happen now a again normally if if I raise the nozzle a little the nozzle will print over this bump. What i see is high spot on the bed...

In marlin firmware this is done during coding. In Configuration_adv.h > search for "// @section advanced pause" There is a section for "Advanced...

I suggest the you check the solder connections for the Bed heater Mosfet , see it there is a cold solder connection on main board.