- Tab Content
- Roberts_Clif's Activity
- About Me
- Friends
- Tab Content
-
Older Activity
-
Today, 05:21 PMRoberts_Clif replied to a thread Ultra Newbie questions. Cheap 2 color unit? Heat tolerance of parts. in General 3D Printing DiscussionI have purchased two of these https://store.anycubic.com/products/kobra-3-combo You may what to have a look they print pretty well. ...2 replies | 429 view(s)
-
02-14-2025, 03:38 PMShould have included a case photo also here is one. My hinges are on top and lifted up no heater just a vent fan on low speed. Two thermometers...3 replies | 1245 view(s)
-
02-13-2025, 08:33 AMI operated my enclosure at 80-100F this is not above the 3D Printers standard operation temperature. The main goal for the enclosure is to stop the...3 replies | 1245 view(s)
-
02-12-2025, 08:45 PMI Have three Hictops 3D Printers they are similar to the ENDER 3 V2 One 12 volt printer and two 24 volt printers. This is my V-Ref values for 9...2 replies | 793 view(s)
-
01-28-2025, 08:06 PMPLA+ requires a little hotter nozzle and a little faster print speed, reduce retraction to about 1mm, enable Z-hop to about 0.4mm4 replies | 3012 view(s)
-
01-28-2025, 08:21 AMRoberts_Clif replied to a thread Bad Neptune 4 Max Layering Problem;; Help Please in Tips, Tricks and Tech HelpELEGOO NEPTUNE 4 PRO: How to adjust the eccentric wheel? https://www.youtube.com/watch?v=PdIiIy7f1Jk Hope this helps1 replies | 1917 view(s)
-
01-23-2025, 08:23 PMHi airscapes I had three older 3D Printers but none of them can 3D Print aluminum. I still have 2 Older Hictop 3D Printers and 2 Newer Anycubic...5 replies | 3192 view(s)
-
01-23-2025, 09:04 AMThere are many things that could cause this problem. 1. Nozzle could be damaged 2. Smooth Rods and Rod bearings could be dirty or insufficiently...2 replies | 2855 view(s)
-
01-21-2025, 08:49 PMRoberts_Clif replied to a thread Help me choose the right printer for me please in 3D Printers (Hardware)Ok so you are wanting a 3D Printer. First printer you stated maybe a Anycubic Kobra 3 currently have two myself and two Hictops 3DP12. I find Kobra...7 replies | 4834 view(s)
-
01-18-2025, 09:58 AMI am posting my Hictop 3DP12 3D Printing on a Anycubic Kobra 3 smooth bed surface. ...0 replies | 1548 view(s)
About Roberts_Clif
Basic Information
About Roberts_Clif
- Location:
- Washington State, USA
- Occupation:
- Electroncis Tech / IT / Programmer
- Thingiverse:
- Roberts_Clif
Statistics
Total Posts
- Total Posts
- 1,203
- Posts Per Day
- 0.43
General Information
- Last Activity
- Today 05:28 PM
- Join Date
- 06-12-2017
Flashforge Adventurer 3 Pro...
02-13-2025, 01:47 AM in General 3D Printing Discussion