TTVert
Technician
Find latest postsMini Statistics
- Join Date
- 02-16-2017
- Last Activity
- 07-31-2022 11:24 AM
Recent Visitors
This page has had 9,765 visits
- Tab Content
- TTVert's Activity
- About Me
-
Older Activity
-
07-25-2022, 02:49 PMTTVert replied to a thread Duplicator i3, what are YOU doing for out of filament sensors? in General 3D Printing DiscussionWell that's helpful.. I did fabricate a mount for a switch and it works well. I just would really like to move that filament sensor to where it...2 replies | 941 view(s) -
07-21-2022, 05:22 PMTTVert replied to a thread Interesting print "defect" that does not occur around the entire print in Tips, Tricks and Tech HelpI will give it a go, I've always been able to print at this speed/temp before w/o the issue. This spool of filament is about done but I'm curious if...2 replies | 872 view(s)
-
07-21-2022, 04:27 PMTTVert started a thread Interesting print "defect" that does not occur around the entire print in Tips, Tricks and Tech HelpThis is a round piece. Specs:The printer is a Duplicator i3+. I'm printing PLA (205C) Outer wall at 60mm/secInner at 80mm/sec.030mm layer height. ...2 replies | 872 view(s)
About TTVert
Basic Information
Statistics
Total Posts
- Total Posts
- 79
- Posts Per Day
- 0.04
General Information
- Last Activity
- 07-31-2022 11:24 AM
- Join Date
- 02-16-2017
Rollator walkers
08-16-2022, 11:23 PM in Off Topic