Emil123
Student
Find latest postsMini Statistics
- Join Date
- 09-26-2016
- Last Activity
- Yesterday 02:34 PM
Recent Visitors
This page has had 2,295 visits
- Tab Content
- Emil123's Activity
- About Me
-
Older Activity
-
10-08-2018, 02:40 PMI measured the PTFE tube in my finder: 42.15mm long, 4mm OD, 2mm ID.1 replies | 467 view(s) -
10-08-2018, 03:28 AMI just ignored the warning, it wasn't a problem for me. I just though you would like to know about it :)31 replies | 9018 view(s)
-
10-07-2018, 06:51 AMEmil123 replied to a thread FF Finder - Print quality suddenly worse after failed print in FlashForge ForumI noticed my pictures got scaled down enough to make it hard to see the problem clearly, so I have uploaded higher resolution images: Under...2 replies | 251 view(s)
-
10-07-2018, 06:47 AMIt doesn't need to a very good conductor to be ESD safe. I have used Protopasta conductive filament to print ESD safe parts. While it may be...10 replies | 2821 view(s)
-
10-07-2018, 02:41 AMI downloaded the latest 64-bit installer on Windows 10. Windows Defender showed this message: "Windows Defender SmartScreen prevented an...31 replies | 9018 view(s)
-
10-06-2018, 03:23 PMI have bought from their website a few times. Fast shipping (considering they are in China) and good quality.2 replies | 707 view(s)
-
10-06-2018, 02:31 PMWhile you can't print BBs, you could print pretty much any part of the airsoft gun that doesn't need to be metal.11 replies | 890 view(s)
-
10-06-2018, 02:21 PMEmil123 replied to a thread FF Finder - Print quality suddenly worse after failed print in FlashForge ForumI tried one more thing: I suspected the problem might have something to do with print temperature, but printing at 210 and 230 degrees resulted in ...2 replies | 251 view(s)
-
10-04-2018, 03:13 PMEmil123 started a thread FF Finder - Print quality suddenly worse after failed print in FlashForge ForumA few weeks ago I was doing a large print wich failed halfway trough as the printer stoped extruding. The print had bad surface finish and a lot of...2 replies | 251 view(s)
About Emil123
Basic Information
Statistics
Total Posts
- Total Posts
- 13
- Posts Per Day
- 0.02
General Information
- Last Activity
- Yesterday 02:34 PM
- Join Date
- 09-26-2016
- Referrals
- 0
Newbie question.
10-15-2018, 05:30 AM in General 3D Printing Discussion