- Tab Content
- Firepower's Activity
- About Me
-
Older Activity
-
Today, 09:41 AMFirepower replied to a thread HELP - First Row Not Printing Properly in General 3D Printing DiscussionThanks for the reply. After sorting out the bed levelling I went back to PLA and it prints great all the time. Must be that the levelling is not...8 replies | 350 view(s)
-
02-12-2019, 09:52 AMFirepower replied to a thread HELP - First Row Not Printing Properly in General 3D Printing DiscussionSounds like you have yours set up good. I do need to replace the wing nuts as they are very loose on the bolt. To get my screws up tight I will...8 replies | 350 view(s)
-
02-11-2019, 06:23 AMFirepower replied to a thread HELP - First Row Not Printing Properly in General 3D Printing DiscussionCURIOUS AARDVARK . I have been doing four outlines and has helped and on the last big base item I am doing one side did not print so was able to...8 replies | 350 view(s)
-
02-02-2019, 08:59 AMFirepower replied to a thread HELP - First Row Not Printing Properly in General 3D Printing DiscussionThanks. I'll look at doing outlines. But even when the base of the print is very big it will all be broken up on the first row. It does not come...8 replies | 350 view(s)
-
02-02-2019, 06:22 AMI have had the Cocoon Create (Wanhao Duplicator i3 V2) 3d printer for years and always had a problem with the first row not printing properly. PLA...8 replies | 350 view(s)
About Firepower
Basic Information
Statistics
Total Posts
- Total Posts
- 47
- Posts Per Day
- 0.04
General Information
- Last Activity
- Today 09:42 AM
- Join Date
- 02-18-2016
- Referrals
- 0
New $139 Kossel Linear on ebay?!?
02-13-2019, 10:46 AM in 3D Printers (Hardware)