scratch1
Student
Find latest postsMini Statistics
- Join Date
- 11-21-2024
- Last Activity
- 12-10-2024 09:11 AM
Recent Visitors
This page has had 1,794 visits
- Tab Content
- scratch1's Activity
- About Me
-
Older Activity
-
11-25-2024, 10:57 AMGood Day Roberts_Clif I pray you had a good Sunday. My printer is an "ENDER 3" all stock. The Bigtree SKR 1.4 Turbo board has the TMC 2209 drivers....13 replies | 7785 view(s) -
11-24-2024, 01:46 PMGood Sunday Roberts_Clif It is a "ENDER 3" Mean while I will view the link you gave me.. David13 replies | 7785 view(s)
-
11-23-2024, 11:16 PMNot sure - It don't have a BL Touch it does use end stops.so must be the 4.2.2 David13 replies | 7785 view(s)
-
11-23-2024, 10:27 PMYes an Ender 3 the one sold in 2017. David13 replies | 7785 view(s)
-
11-23-2024, 09:49 PMCompletely stock - only the TMC 2209 drivers David13 replies | 7785 view(s)
-
11-23-2024, 09:15 PMThanks for the reply Roberts_Clif I am looking for the current Marlin software set up for the BIGTREETECH Direct SKR V1.4 Turbo Control Board +...13 replies | 7785 view(s)
-
11-23-2024, 10:06 AMA few (6) years I purchased a Creality 3 printer, I then upgraded the mother board to a BIGTREETECH Direct SKR V1.4 Turbo Control Board + 5pcsTMC2209...13 replies | 7785 view(s)
About scratch1
Basic Information
About scratch1
- Biography:
- MAN
- Location:
- USA
- Interests:
- 3D
- Occupation:
- YES
- 3D Printing Emails
- Signup
Statistics
Total Posts
- Total Posts
- 7
- Posts Per Day
- 0.33
General Information
- Last Activity
- 12-10-2024 09:11 AM
- Join Date
- 11-21-2024
What is the best material type for...
12-06-2024, 01:16 PM in General 3D Printing Discussion