VidJunky
Student

I'm using the same brand printer and I've never tried slowing down the first layer. I see where that would help but for me, I usually clean the plate...

I'm on day 10 or 11 and this is pretty straight forward and starts off simple. It's better if you have dual monitors and can run the video on one...

That is super clean. Nice work. I'm lost when it comes to modeling.

You could start the print at an angle and only print some of it vs fully committing and trying to print it all. I do small test prints a lot to cut...

I've had a similar experience where my print may have succeeded if only the slicer had made longer straight lines instead of jumping around. I...