VidJunky
Student

If you have to go with two or more heaters, I believe the better alternative would be to get a controller with multiple outputs to control each zone...

Welcome to the forum. What do you mean you printed 10 pieces? This looks like one of those prints that prints as a conjoined print in place toy. ...

Releveled or rehomed? It sounds like you needed to home it if it was running above the bed. Anyway, glad you figured it out. Good luck and best...

I had to look up what this was, and I'm still not real sure. Anyway, I see it mentioned with the Ender 3 a few times but not the Pro version. Not...

If you're open to Fusion 360, here is a whole 30 lesson course for free on how to model and design in autodesk. ...

That looks like it should do the job starting out. If it is working for your needs that's all that matters. I pulled this video for you. Just...

Granted I only print at work, but I use Grainger and feel like I get decent pricing. As for why some may be more than others, some if it is the...

Fusion is my go to for sure. I print mostly for work, not as work but for my place of employment. Anyway, a friend of mine suggested this course on...

The printers I used just sat on a spare desk, nothing special and for the most part I got good prints off of them. It was more about the time I spent...

If you can't print ABS I think you might struggle to print PETG, or at least I did. I was looking for something a bit stronger than PLA and PETG had...