- Tab Content
- VidJunky's Activity
- About Me
-
Older Activity
-
10-26-2024, 04:25 AMSo I was getting these marks and I felt like I was also having issues with my prints due to the feed rate of my filament. Like you I was getting...2 replies | 8521 view(s)
-
10-26-2024, 03:32 AMMy Prusa MK 3 is direct drive vs my Creality printer which has a long tube that guides the filament to the extruder. A quick Google image search will...4 replies | 14008 view(s)
-
10-09-2024, 06:42 AMVidJunky replied to a thread prusa mk3s: first layer lifting in a ripping fashion in Tips, Tricks and Tech HelpI'm using the same brand printer and I've never tried slowing down the first layer. I see where that would help but for me, I usually clean the plate...7 replies | 6884 view(s)
-
10-09-2024, 06:23 AMPretty sure this would qualify as a tip. A friend of mine was struggling with a project and happened upon this series and then turned me on to it. It...0 replies | 1819 view(s)
-
10-09-2024, 06:15 AMI'm on day 10 or 11 and this is pretty straight forward and starts off simple. It's better if you have dual monitors and can run the video on one...2 replies | 10868 view(s)
-
10-09-2024, 06:02 AMThat is super clean. Nice work. I'm lost when it comes to modeling.4 replies | 6589 view(s)
-
10-09-2024, 05:38 AMYou could start the print at an angle and only print some of it vs fully committing and trying to print it all. I do small test prints a lot to cut...2 replies | 8796 view(s)
-
10-09-2024, 05:36 AMI've had a similar experience where my print may have succeeded if only the slicer had made longer straight lines instead of jumping around. I...2 replies | 8796 view(s)
About VidJunky
Basic Information
Statistics
Total Posts
- Total Posts
- 11
- Posts Per Day
- 0.14
General Information
- Last Activity
- 10-26-2024 04:25 AM
- Join Date
- 08-19-2024
Kickstarter campaing LEGENDARY...
Today, 01:13 PM in Free Self Promotion