David7200
Student

I’m missing something here. The extruder puts out a cylinder of semi molten plastic 0.4mm wide. The Z axis moves by 0.2mm. So how does the...

When you print with filament and you have a height that's shorter than the diameter of the extruded filament, that filament gets squished down to...

I'm new to this but if you are looking for tolerances of 0.001 inches you are probably looking at the wrong tool for the job. You might look into...

I have a new X-Plus3. It has a filament runout sensor. It didn't stop my printer. Is there something I need to do to enable it or is this a...

I'm using rapid PLA. I clean the print bed every time with 70% isopropyl alcohol on a paper towel. I increased the bed temperature to 60C.This...