3DPrinterMan1234
Student

IS the nozzle the standard 0.4mm the genial rule is no bigger that 75% of the nozzle size.

It depends on price. Review can be helpful speed not so much, if warranty is important to you look for a good warranty but it doesn't really matter...

Yeah good luck

Try lowering the print temp and leveling the bed

In the support section there will be a setting called support pattern try changing that. if it doesn't show up click the slider button and click the...

glad i could help

You could try a firmware like th3ds or marlin this is a link for the th3d version. https://www.youtube.com/watch?v=cD3BTMKq3GA

it could be a z axis loose or bent that's probably my only idea. :)

I think you need to use different supports so that it is properly being supported.

i don't think that is the actual bed i think you are printing of the wrong thing i dont think that is the problem but

Ok great that it work out

You could try using z hop if you think it is hitting something just turn it in your slicer.

Hello It looks like wet pla you can tell if you extrude some and you hear a crackling noise or see steam coming off. This can be fixed by drying it...

Have you tries using youtube for help.

on the inner side of the box where the wall is coming off

Just watch the fumes

A couple of ideas 1. it could be a filament tangle makers muse has a great fix https://www.youtube.com/watch?v=c20nrF4b8-g 2. usually speaking all...

Yeah i print pla ad nozzle 200 and bed 60. never use a hammer to get prints of both dangerous and damaging. try heating the bed up to around 65 and...

yeah try tightening the z axis screw

You might need to use supports for a over hang like that and also maybe level the bed Have a great day :)

Try heating the bed to you printing bed temp than gently pry it off have a great day :)

Yeah use susport on prints like this. they can be turned on in your slicer for any prints with overhangs

Cost for me i don't know about you thought

To start best things making things that you have designed printing replacement parts printing in genrial Worst things cleaning wasting...

Try doing a bed level and a bed clean with some mentholated spired and a paper towel. You could also put some adhesive on your bed there are plenty...

Hello When i was first starting i made so many mistakes it is a part of learning. i don't have a cr touch but i have a bl touch and when i was...

It could be a loose z axis screw try tightening you little black screws at the bottom of the z axis screw.Have a great day.:)

Hello i use tinkercad it is a website just google tinkercad and import your stl then use square hole of the right and possession it correctly and...