Activity Stream
-
Older Activity
-
Yesterday, 10:35 AMSTL Fun Forge started a thread Kickstarter campaing MODULAR STL FANTASY WEAPONS in Free Self PromotionHello everyone, we are proud to share our new kickstarter campaign dedicated to our customisable fantasy weapons compatible with our modular sabers...0 replies | 196 view(s)
-
Yesterday, 08:58 AMHi everyone, our new campaign is coming soon :)18 replies | 7914 view(s)
-
04-16-2024, 12:32 PMBikeracer2020 replied to a thread Catastrophic failure on Creality Ender-3 V3 KE in Tips, Tricks and Tech HelpThe filament monster is probably because the nozzle has a less than perfect seal to the hot end, causing the molten filament to leak. I don't know...1 replies | 373 view(s)
-
04-16-2024, 12:01 PMKalkowski started a thread Catastrophic failure on Creality Ender-3 V3 KE in Tips, Tricks and Tech HelpHi, i am new to 3d printing, this is my second printer, bought brand new 2 weeks ago.i have been using the factory settings and regular PLA...1 replies | 373 view(s)
-
04-16-2024, 07:41 AMIt sounds like moisture to me as well. I may have missed it but have you tired putting some cardboard or something around to create a simple...188 replies | 319305 view(s)
-
04-15-2024, 05:36 AMsamsonwilliams started a thread Creating a bronze-Like finish for outdoor 3D printed plaque in General 3D Printing DiscussionDoes anyone know how I could paint a 3D printed plaque so that it looks like its bronze? It will need to hold up outside with the desert sun beating...0 replies | 716 view(s)
-
04-14-2024, 08:58 PMI have printed for a few years on a Creality Ender-5 with few problems. I have some rather small parts that are doing fine with a 0.4mm Nozzle, but I...0 replies | 370 view(s)
-
04-14-2024, 05:15 PMIn my Slicer Software there is an option to randomize location of seam to virtually make it invisible.2 replies | 692 view(s)
-
04-14-2024, 12:34 PMWell it looks kind of dumb but it works. I have a 235X235 build sheet (for an Ender) stuck to a 235X235 PEI build plate (also for an Ender) I...5 replies | 3169 view(s)
-
04-14-2024, 11:26 AMI made the z change in the printer itself. It is a delta running smoothieware so it is very easy to make changes in the firmware. Then I fine...5 replies | 3169 view(s)
-
04-14-2024, 01:46 AMDid You adjust the 'Z' offset in the slicer or just the 'Z' height when setting the initial nozzle difference? I should have made that clearer in...5 replies | 3169 view(s)
-
04-13-2024, 02:50 PMI have been struggling with these plates for almost a year now. I have a cartesian and a delta printer. I print PETG and ABS on the cartesain and...5 replies | 3169 view(s)
QIDI Slicer "Plater" is...
04-12-2024, 02:21 AM in QiDi 3D Printer Forum