Prusa mendal I2 Pronteer face Marlin error

[jakers181008]

While unplugging everything and plugging it back it i found a couple of end stops in the wrong place, will test now

[jakers181008]

x_min: TRIGGERED
x_max: open
y_min: open
y_max: open
z_min: open
z_max: open


now i'm getting this, all of the other switches work, part from x, the just stays triggered....


also the motors now move park from x for obvious reasons

[jakers181008]

Hi guys been a very busy week but now working on the printer again,


I have sorted out the switch, it was a simple connector fault, replacing fixed that.


now just the X motor just makes a juddering noise sort of like a machine gun. i've increased the voltage a tiny bit but still not working, must be something to do with the acceleration? also the extruder is doing the same. just the jittering is much slower? i need to get another feeder thingy, the one that drips onto the filament and pushes it down. will go buy that today :/ didn't last long, saying that i haven't even been able ti use the motor to drip the filament :/

[jakers181008]

just tried changing the x y manual feedrate to 100, but it is still making the junting noise but not as quick anymore. and when i turn up the voltage on the board, it's just makes the noise louder.. :/

[jakers181008]

Hey guys, if any of you want to help me, i got skype think that would be quicker at solving my issue if anyone wants to help

Jakers181008
Also my email is jakers181008@gmail.com

hopefully i'm very close to getting this working.

Thanks again,
- Jake

[jakers181008]

okay i've just made a few more tests to see what the problem is. i've changed over the stepper motors, i changed x with y, and now y does not move.

i've changed the driver board and that makes no difference

i've double checked the voltage on the board and that made no difference art from making the clicking noise louder...


Any ideas anyone?

[jakers181008]

PS i have taken the pulley off of the stepper motor for now as i thought it was causing too much friction, but that didn't help it at all

[jakers181008]

Hi guys just tried out cura by ultimaker, looks like a nice piece of software, what would you guys recommend using when i get the last two motors working?


Regards
- Jake

[Mjolinor]

What ever you use I would recommend that when you ask for help on Skype you respond to requests to add people because without that it is not possible to help.

I had a couple of hours to spare this afternoon but it's too late now.

[jakers181008]

i swear i'm going to throw my ipod out the window, never tells me anything, maybe another time?