Results 1 to 2 of 2
-
08-25-2014, 01:19 PM #1
- Join Date
- Jul 2014
- Posts
- 3
Mendel. Stopped connecting and printing
Hi,
I have a 3d printer with marlin firmmare. Couple of days ago it suddenly stopped connecting through software and printing. If i print through SD card it began to heat up but after that nothing happens. But the thing is that when i came to a service point it began printing through their PC and SD card. Like some kind of magic.
But when i connected it again on my pc - the things remain the same... So i took it home and tried on my home PC and laptop - it still doesn't want to connect and print neither. Maybe i should install some addition software\drivers? I installed just Cura and arduino drivers (which Cura includes)
Thank you
-
08-26-2014, 11:10 PM #2
- Join Date
- Aug 2014
- Location
- London, UK
- Posts
- 3
try to reinstall the software or check if the cable/cord are fine if not immediately buy new one then try it out again hope this will help.
Extruder not feeding during print,...
Today, 01:59 AM in Tips, Tricks and Tech Help