Results 1 to 10 of 39
Threaded View
-
09-03-2014, 05:56 PM #28
I have noticed that sometimes when the printer is printing in a small spot for to long, the standard temp that works for everything else can actually be too hot. Almost like it is just re-melting the piece and pushing it around. That's why I like to have a little temp control, while printing. Repetier allows for this, Makerware doesn't. It just takes a little experimenting with temp. I will admit I haven't done much on printing figurings, but I have seen a difference of small print area to large print areas. Maybe, try printing two of those small prints, on the same print, to see if it helps.
Print not sticking to base plate?
Yesterday, 01:26 PM in General 3D Printing Discussion