Close



Results 1 to 2 of 2
  1. #1

    Makerfarm i3v heat bed not heating up

    Woke up this morning to a finished print, came out great. I went to start the second part and the bed wont heat up. I just got done changing the wires twice and the thermistor is functioning, goes up when I put my finger on it

    Could something be fried on my ramps? I have an extra so that's probably my next step.

    thanks in advance.

  2. #2
    turned out to be the spot for power on the ramps board melted.. luckily I had another fried ramps so I did a swap and all is well.. Made a mount for a 60mm fan to cool it off and turned my voltage down on my power supply a little.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •