Slicer won't bridge this gap nicely ????

[Roxy]

I used to have real good luck bridging gaps. But now I can't get Slicer to bridge the gap in a clean, nice way.

And depending upon which version of Slicer I use, it fails in a different way. The latest version (experimental V1.1.2) does the best, but it still screws up the perimeter of the bridge.

I've shrunken the failure down to a 5 minute print so you can see what I'm fighting.

If you can make it bridge cleanly... Can you please tell me what version of Slicer you are using and include your Print-Settings ???? It would help me immensely!