I have a HE3D K280 printer and I printed out two prints (First time printing) when I ran into a decoupling error. I checked to see if there were any volts going through the place where the wire connected to the board (there were about 24v) and checked if the temp sensor was working; it did.
I got a hair dryer and blew hot air on the temp sensor as I told the heater to heat to 200C. So I basically tricked it to believe the heater was heating up, so it continued to heat itself instead of giving me an error ("dec" on the LED screen).. This should indicate that there isnít anything physically wrong?

I am dumbfounded as to why. I did buy a spare one but I donít know why itís giving me this error and hoping it isn't related to the board.