I'm using a Maker Select. Cura 15.0.46 (I know, i know. I print via USB and 3.0 prints off random 90 degree lines to the end of the bed. Others had same issue and just print via SD which I do not want to do. Anyway, i have support type set to everywhere however it is only building supports maybe an inch out. I've included pictures. I've never run into this before., has anyone else? Any suggestions? I normally wouldn't print in this orientation but I figured w/ supports it'd be fine and this orientation cut an hour off the print time. I always have very good adhesion and I think what is actually touching the buildplate will support this print but It's a longer print and I cannot really test the theory quickly so i'm letting it go. Anyway, here is the cura and print view currently. (Note that the actual print is 180 degrees to the cura view)
cura.jpg
2018-01-05 13.14.06.jpg


Thanks guys
Dave