Hi all, it's probably easier explained by video so here's my video:

https://youtu.be/ed112bOVxpw

As you can see, when I use Repetier to move the printhead on the x-axis, it triggers the end stop and all is well. But when I select Home, it keeps bashing away at it for about 10 seconds or so, until it finally gives up.

I've got the latest Geeetech firmware on it and have not changed any settings (other than inverting the y-axis as it was homing the wrong way).

Any advice appreciated. I've not been able to print anything on it yet due to this issue. I can't trust it with this issue outstanding (!!)

Perhaps there's a way to offset the home position but I figured it should stop when it hits the end point switch, right? It's almost as if the home position needs calibration or offsetting? Or am I off-track here? Many thanks.