1.jpg2.jpg3.jpg
I have a CTC Dual Extruder with makerbot desktop. I've been strugling for a while trying to fine tune this in the software. My prints are currently coming out like this. Could anyone show me some snapshot of what theyre settings are in markerbot desktop?
I am printing with ABS, right extruder - 235 deg C, 110 deg C board with blue painters tape, I've recently cleaned the nozzles and leveled the board. The infill seems to be separated from the shell, and the lines arent always consistent. I am under the impression that I need specific settings in the software to fix the quality of these prints but I have no resources to go off of. Could anyone help?

Thanks in advance!