Close



Results 1 to 1 of 1
  1. #1

    Zmorph extrusion amount issue

    Hello.

    I have problem with overextrusion in my Zmorph printer. Using dedicated software(Voxelizer) I can easily adjust it by filament diameter. Although I prefer to use slic3r and the problem is that changing filament diameter or extrusion multiplier in slic3r doesn't affect print at all. Even with big change print is equally overextruded.

    Why this could be?

    I deleted most of voxelizers file as it was large.

    Attachment 10811test_slic3r.gcode
    Attached Files Attached Files
    Last edited by MeepleMorph; 07-24-2017 at 04:08 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •