TLDR; one side of my print is totally falling apart20170624_192026_small.jpg20170624_192037_small.jpg20170624_192053_small.jpg20170624_192026_small.jpg20170624_192037_small.jpg20170624_192053_small.jpg

Hello! Total newb here. My wife bought me a 3D printer for father's day because she knows that I like to tinker with things and I had shown some interest in the one at my son's school. She purchased me an FLSUN delta 3D printer on Amazon and having received it, as a software engineer I felt pretty confident I could work through the Chinglish instructions and get this thing running. Which, largely, I did with varying degrees of success. That led me to looking up every calibration video and thread I could find and largely that helped produce much better results. However, after hours of looking through threads, I am at a loss. I have an issue on 1 side of the printer that persists no matter what the print settings are. I have leveled, auto-leveled, made adjustments to the printing parameters, but it persists, reading through these forums has been the greatest source of knowledge to me since I began and I'm hoping that someone can point me in the right direction. Images available, I was unable to attach them; presumably I am still too new to the forum. And thank you for any help you can provide.

Print temp: 1st layer 210 then 195
Bed temp: 1st layer 65 then 55
Retraction 2mm, -0.6 on restart
Print Speed: 50
Layer ht: .1