Close



Results 1 to 3 of 3
  1. #1

    Wanhao i3 wont stop when my probe is activated (ramps1.4) PLEASE HELP

    I'm switching over my wanhao i3 that had a z probe with stock board and marlin to ramps with repetier firmware. It doesnt stop when my zprobe is activated. I use M119 and it shows that my zprobe and my z min(which is my probe in the min pins) is H when not activated and L when activated and i set the firmare to be normally closed. Please help



  2. #2
    Super Moderator Roxy's Avatar
    Join Date
    Apr 2014
    Location
    Lone Star State
    Posts
    2,117
    If you have Repetier firmware.... You don't have Marlin. If you had Marlin firmware, I could help you.

  3. #3
    i was using repetier but i figured it out on marlin, thanks though.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •