Close



Results 1 to 3 of 3
  1. #1

    CR-10 Possible underextrusion?

    Hi everyone,

    I recently bought a CR-10, and I decided to print a Benchy at 0.05 mm layer height with 15% infill. I noticed that there are holes/gaps in the support (as shown in the picture below). I thought this could have been underextrusion, but the other areas printed flawlessly. I am also pretty sure that the top layer didn't fill in completely since I only used 2 perimeters. I used Craftware to slice this. Could anyone help me with a possible reason as to why there are gaps in the support?

    printer1.jpg

    printer 2.jpg

    printer 3.jpg

    Thanks,
    Protolate

  2. #2
    Old thread, but incase you never found what was causing this, it's usually too fast printing speed.

  3. #3
    ProtolateTry slowing your print down while it is printing. Turn the knob to reduce F/R on the control box.John

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •