Close



Results 1 to 5 of 5

Threaded View

  1. #1

    CTC Bizer communications problem

    Working on a CTC Bizer, dual extruder printer at the local makerspace.
    Prints OK from SD card but I can't get a USB connection to work.

    I'm planning to use Octprint on a Raspberry Pi but it won't make a USB connection.
    Running a 'dmesg' command on Linux shows the correct USB port that the printer is connected to and that the device (printer) is a Makebot 1 running Relicator and a serial number. Ths shows that the USB is initialising OK
    I've even tried connecting to the printer via a terminal program but no response that way either. Baud is set to 9600 on connection. Tried at 11500 as well with same result.

    I'd like to upgrade the firmware but obviously need a USB connection to work first.

    Regards
    Geoff
    Last edited by GeoffS; 04-04-2017 at 08:23 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •