Close


Signup for our Free Webinar


Results 1 to 2 of 2
  1. #1

    .8 nozzle troubleshooting

    I have a monoprice maker select printer and I am using Cura as my splicer. I have been using a .4 nozzle and have had a lot of success with the printer, but I recently bought a mk10 .8 nozzle for an upgrade and now the printer will touch the bed, then begin the print and print 1 to 1.5 millimeters above the bed. I am not sure why a .8 nozzle would cause my slicer to have it print that high but is there a way to fix this issue?

  2. #2
    Another question! I am barely printing at 1.5mms per second, is that speed too low for my printer?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •