Close



Results 1 to 2 of 2
  1. #1
    Student
    Join Date
    Feb 2017
    Location
    Muskego, WI
    Posts
    1
    Add alecmesa96 on Facebook

    Question Wilson 2: What are these zits in 3DBenchy?

    Hey everyone, new guy here, I'm coming from an XYZ Printing Da Vinci Jr 1.0, so I'm used to easy and calibration free printing. I picked up a kit for the Wilson 2 and have recently finished putting it together and got some prints going. First thing I printed was 3DBenchy, to get the calibration out of the way. Everything looks good so far but I still see a few zits and I can't really figure out why they are showing up. Esteps/mm is calibrated correctly, since if I turn flow rate down i start to see gaps.

    Anything I can do to correct this? I am using the creator's cura settings so they are *supposed* to be the best settings for this printer.

    Here is the Imgur album with the pictures. http://imgur.com/a/G73wU

    Any input is greatly appreciated!

  2. #2
    Staff Engineer printbus's Avatar
    Join Date
    May 2014
    Location
    Highlands Ranch, Colorado USA
    Posts
    1,437
    Add printbus on Thingiverse
    Since no one else has responded, what I usually do on print quality issues is refer people to the print quality troubleshooting guide at Simplify3D. Some of the dialogue may be unique to the Simplify3D slicer, but it may still provide some generic suggestions for you. Look for the "blobs and zits" category.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •